They say the eyes are the windows to your soul. In our home, our windows are our eyes to the world. With good windows (Texas Replacement Windows), we will be protected from different weather conditions. This is especially important in people living in Texas, where the weather can be really hot during summer and cold in winter. With good and functional windows, we will be secured inside our houses without being totally unaware of what is happening outside our homes. This is why keeping your windows in good form (Austin Window Replacement) is very important.
Here are some steps you can follow to prepare your window for replacement.
Materials and Tools You will Need:
• Tape measure
• A small prybar
• Utility knife
1. Check your windows.
Assessing your windows (Austin Replacement Windows) on a regular basis will help you repair damages immediately. This will also save you money. Minor damages are cheaper to repair than major ones. Don’t let any damage gets worse by not repairing it on time.
Try closing and opening your windows a few times to see if they open and close correctly. Listen for noise when you move your window. It might signal parts that need to be oiled or replaced. Look for broken seals by checking if the light passes through.
2. Choose a frame
There are different types of frames to choose from (Texas Vinyl Siding). If you are after the cost, your best bet is a vinyl frame. This is the cheapest frame on the market. A vinyl frame is very easy to maintain. It commonly comes in light colors. Other types of window frames (Austin Siding) that you can use are wood frames and fiberglass or composite frames. Fiberglass or composite frames are the most expensive frames you can buy.
3. Get measurements
The right way of measuring a window (Texas Vinyl Siding) is from the right inside jamb to the left inside jamb. It’s also important that you measure the top, middle and bottom of your window. Keep in mind that warping is very common, so you also need these additional measurements. Measure your window vertically from the inside of the sill to the inside of the top window jamb. Again, the sides and middle part should also be measured. Get the smallest among the measurements.
4. Remove stops
The parts that hold the sashes vertically are your window stops (Texas Replacement Windows). Use a prybar, utility knife and a screwdriver to remove the stops. Be careful in removing them to avoid damaging other parts. Do not throw away the window stops. You can use this in your new window.
5. The sash cords
The moving part of your window (Round Rock Window Replacement) is its sash cord. Remove the inside sash first. Take out the outside sash by carefully sliding it down and removing the strips that hold the sash in place. Do not remove the outside stops.
Assessing and preparing your windows for replacement (Texas Replacement Windows) is easy. Save on additional costs by doing it yourself. Contact a Texas replacement window company (Texas Replacement Windows) in your area, and let them help you replace your worn out windows.